Adventurer 5M and 5M Pro First Time Setup / Unboxing
Flashforge
Flashforge
Step into the unboxing journey of Adventurer 5M Pro. Step 1: Unboxing Your Printer After opening the box, remove the upper foam and fixing cardboard. Remove t
Hardware Steps / Preparation
- Unbox and remove tape, film, etc.
- Remove foam from inside top lid
- Install spool holder on back
- Remove bed screws ⚠️ (IMPORTANT), use the included 2.0mm allen wrench
- Turn on
- Perform self calibration (5-10min)
- Load Filament
You are now ready to perform a test print from the internal memory if you'd like.