Connect Your Printer
Connect your 3D printer in just a few steps. It all starts here!
Connect a Printer
-
-
TECH-201: Connecting Printers
Earn your "Printer Connector" certification by completing this assessment.
-
Accessing Your Printer's Camera Feed
Checking on your print via the printer's built-in webcam is a great way to add a little peace-of-mind to your printing.
-
Dremel Digilab 3D40/3D45
Learn how to connect your Dremel 3D Printer, view the camera, and troubleshoot common issues.
-
Flashforge Resellers (Afinia, Monoprice, Bresser, Robo, Arçelik, etc.)
Flashforge private-labels a number of other printers available on the market. For those that ship with Polar Cloud Enabled firmware, learn how to connect them here so you can view your camera and start sending prints.
-
Viewing your 3D Printer's Camera - Flashforge Adventurer 3 / MP Voxel / Bresser Rex
Checking on your print via the printer's built-in webcam is a great way to add a little peace-of-mind to your printing.
-
Reprap / Other (via Octoprint)
Through OctoPrint's support of the Polar Cloud, you can securely control your 3D printer remotely over the Internet! To see if your 3D printer is supported by OctoPrint, check OctoPrint's supported printers page.
-
-
Printer Compatibility
Is your 3D printer compatible with the Polar Cloud? Start here to find out.
-
Troubleshooting an "Offline" Printer
Printer showing up as OFFLINE? Get it back online by following these steps.
-
